Hi

this morning I was scanning away (in photoshop via the twain driver) and Nikon Scan strangely misbehaved during the subsequent feeding of another strip into the SA-21. I get the following error message:


could not complete the import command because of a problem with the acqusitoin module interface

then the twain driver refused to exit.

I had to quit photoshop, and got an error about the software referencing a memory location which it can't.

anyone got any ideas?

naturally i've rebooted twice and re-installed the drivers

PS ... I have now confirmed that my Firewire sub-system is working by having done a scan on my 4990 (which uses firewire too) on the same port and cable as I was using for the LS-4000)

I have notice too that after I load a strip of film I see that the scan interface dialog shows my settings are gray (didn't think they were before) and that my preview and scan buttons are grayed

http://farm5.static.flickr.com/4064/4287698176_2c6114a97f_o.jpg

I can not close it, and so need to quite photoshop. After quiting PS I get the following error message
http://farm3.static.flickr.com/2780/4287698206_8717c97c8a_o.jpg

PPS: after a restart it now works on the FD-3 ... so it seems confined to operations with the SA-21

ok, the problem seems to have been software. I decided to delete all my 'saved settings' and reset to factory default

seems to be going again